A Sequin Free Sewing Post!

Don’t we just love old jeans! All that fading and distressing; it seems such a waste to turf them out just because they’ve worn through on the knees or thighs. This tutorial shows you how to make a gorgeous summer skirt using the bit that never seems to fall apart – the “body”. (You could make this for a child too, you just need a lot less fabric and narrower tiers).
I own a few of these skirts but this one is far too teeny for me.

To make this skirt I used:

• an old pair of jeans
• three summer cotton fabrics, 2.3m in total (0.4m for the top, 0.7m for the second and 1.2 for the bottom)
• ric-rac trim and buttons
• thread

I cut the legs right off the jeans (saving the useable bits for patching other projects), making sure you don’t cut the front pocket bags! If possible save the back pockets. If not, just cut the bottom of them off like I did. (you’ll have to take my word for that!)
Now fold your jeans sideways so the fly is at one end and the centre back at the other. Line up the two layers of waist band and pin evenly.

 

Work out how deep you want the denim basque of your new skirt to be – I made ours 22cm deep. Measure from the waist band to that line and pin every 5cm or so. Then you can cut off any excess carefully along the pinned line through both layers, making sure you don’t cut the front pocket bags again! I did this with pinking shears.

When that’s all done, unpick the curved seam at the front below the fly.   

Lap the original outside over the other side flat, then top stitch through all the layers over the original stitching lines.

Work out what order you want your fabrics to go in – I liked the yellow Amy Butler print breaking up the more blue based other ones. I cut my tiers: 2 widths x 18cm for the top, 3 widths x 23cm for the middle and 4 widths x 28cm for the bottom one. Increasing the tiers towards the bottom like this makes the skirt balance better visually.

 

Now the trick to sewing the three tiers together is to not “over-gather” the fabric or the skirt grows enormous! To get around this, and to avoid the unspeakable horror of the whole gathering stitches, pulling up and pinning, this is what I do:

Join the strips for each layer together, pressing the seams open, so each is a continuous flat strip. Don’t sew the ends of this strip together. The top tier doesn’t want to be two whole widths around, so cut about 55cm off the end for a size 10-16, less for larger sizes.
Starting with the top and middle tiers, I put them right sides together both at the beginning of the strips with the middle (yellow) tier on the top, and I pleat it straight in under the machine foot. In the photo above I pinned the next pleat to show you how deep I make them but in reality I just form the pleat with my fingers and feed it under the foot. Not too deep and not too close together, that’s the trick. Remember you’re just pleating the fabric on top, not the one underneath.
Just keep pleating until you get to the end of the underneath strip. As you can see in the photo, I ran out of top tier just after a seam in the middle tier, but it doesn’t matter, no one notices. Just trim the middle tier so it is “flush” with the top tier.

  

Here’s a pic of the right side showing these two tiers sewn together

 Use the same process to join the last tier to the middle tier. Remember not to pleat too close together or too deeply. Cut any overhang at the end of the final tier.

To make the skirt,  bring the two edges of the skirt together, right sides together, line up the tier seams, pin and sew straight through.

 

 Press the seam open. You may notice that I haven’t neatened any of my raw edges with an overlocker or zig zag. That’s because these kinds of cottons really don’t fray much so there’s no real need to, unless you wish to. To each their own!

I then joined the skirt to the denim basque. In this case, I did use two rows of gathering, and eased it in a little so it just fit, with the one seam down the centre back. Instead of sewing right sides together, I lapped the raw edge of the top of the skirt under the bottom of the basque and sewed them through in two rows. This leaves the raw pinked denim edge on the top layer, which will fluff up with washing like the bottom of cut off jeans.

Cost of project: jeans $5 from an op shop, fabrics $36.80 from the shop's $16m range. Ric-rac was $2m and I used 1m. Buttons were $5, total: $44.80. Not bad!

Building a Christmas Tree Dress

I saw a few of these online and had to make one for the shop. Like Dior made Christmas his own!
So, last Sunday MrC and I purchased a 210cm tall artificial tree, some new lights and baubles, and on Thursday I got stuck in. The mannequin is a new one that is technically for sale in the shop and I felt its black and cream dramatic patterning lent itself to the concept.
I am really uncomfortable with heights even little ones, and working on the 3 foot high display dais was pretty freaky for me. Because taking pics meant getting down and up off it, I didn't capture every stage in the process but here's how I did.

 The mannequin before.

 I tied the small, fluffy branches around the leg to create a petticoat. Tied on with cotton tape.

 The next stage involved gun stapling another layer of longer branches to the underside of the mannequin. Then a layer of the longest branches hooked through a cotton tape around the waist. 

At this stage the weight of the branches caused the base of the mannequin to bust. So, we took the three little feet off and just propped it on a angle into the corner! The skirt is only around the front so it needed an angle to stop it toppling forward.

 Lights! Pink organza around the waist to hide the workings.

 I changed the organza sash to be deeper with no bow, made a necklace out of baubles and hung the baubles, of course.

 The almost completed display  - fake presents and Mel's clever Wall tree made from decreasing rolled up strips of wrapping paper.

A close up of the adorable dress ornaments I bought in Greytown. The six of them cost more than all the baubles but they had to be bought, right? 

I am in love with this display, no other way to put it!