Sunday, November 8, 2015

A Sequin Free Sewing Post!


Don’t we just love old jeans! All that fading and distressing; it seems such a waste to turf them out just because they’ve worn through on the knees or thighs. This tutorial shows you how to make a gorgeous summer skirt using the bit that never seems to fall apart – the “body”. (You could make this for a child too, you just need a lot less fabric and narrower tiers).
I own a few of these skirts but this one is far too teeny for me.

To make this skirt I used:
  • an old pair of jeans
  • three summer cotton fabrics, 2.3m in total (0.4m for the top, 0.7m for the second and 1.2 for the bottom)
  • ric-rac trim and buttons
  • thread
I cut the legs right off the jeans (saving the useable bits for patching other projects), making sure you don’t cut the front pocket bags! If possible save the back pockets. If not, just cut the bottom of them off like I did. (you’ll have to take my word for that!)
Now fold your jeans sideways so the fly is at one end and the centre back at the other. Line up the two layers of waist band and pin evenly.
jeans pair 1 
Work out how deep you want the denim basque of your new skirt to be – I made ours 22cm deep. Measure from the waist band to that line and pin every 5cm or so. Then you can cut off any excess carefully along the pinned line through both layers, making sure you don’t cut the front pocket bags again! I did this with pinking shears.
When that’s all done, unpick the curved seam at the front below the fly.  jeans pair 2 
Lap the original outside over the other side flat, then top stitch through all the layers over the original stitching lines.
j11
Work out what order you want your fabrics to go in – I liked the yellow Amy Butler print breaking up the more blue based other ones. I cut my tiers: 2 widths x 18cm for the top, 3 widths x 23cm for the middle and 4 widths x 28cm for the bottom one. Increasing the tiers towards the bottom like this makes the skirt balance better visually.
j12 
Now the trick to sewing the three tiers together is to not “over-gather” the fabric or the skirt grows enormous! To get around this, and to avoid the unspeakable horror of the whole gathering stitches, pulling up and pinning, this is what I do:
Join the strips for each layer together, pressing the seams open, so each is a continuous flat strip. Don’t sew the ends of this strip together. The top tier doesn’t want to be two whole widths around, so cut about 55cm off the end for a size 10-16, less for larger sizes.
Starting with the top and middle tiers, I put them right sides together both at the beginning of the strips with the middle (yellow) tier on the top, and I pleat it straight in under the machine foot. In the photo above I pinned the next pleat to show you how deep I make them but in reality I just form the pleat with my fingers and feed it under the foot. Not too deep and not too close together, that’s the trick. Remember you’re just pleating the fabric on top, not the one underneath.
Just keep pleating until you get to the end of the underneath strip. As you can see in the photo, I ran out of top tier just after a seam in the middle tier, but it doesn’t matter, no one notices. Just trim the middle tier so it is “flush” with the top tier.

j14  
Here’s a pic of the right side showing these two tiers sewn together
j15
 Use the same process to join the last tier to the middle tier. Remember not to pleat too close together or too deeply. Cut any overhang at the end of the final tier.
To make the skirt,  bring the two edges of the skirt together, right sides together, line up the tier seams, pin and sew straight through.
 j17
 Press the seam open. You may notice that I haven’t neatened any of my raw edges with an overlocker or zig zag. That’s because these kinds of cottons really don’t fray much so there’s no real need to, unless you wish to. To each their own!
j19

I then joined the skirt to the denim basque. In this case, I did use two rows of gathering, and eased it in a little so it just fit, with the one seam down the centre back. Instead of sewing right sides together, I lapped the raw edge of the top of the skirt under the bottom of the basque and sewed them through in two rows. This leaves the raw pinked denim edge on the top layer, which will fluff up with washing like the bottom of cut off jeans.

j20
Cost of project: jeans $5 from an op shop, fabrics $36.80 from the shop's $16m range. Ric-rac was $2m and I used 1m. Buttons were $5, total: $44.80. Not bad!

7 comments:

  1. I made a skirt like this when i was about 14 to copy Star from The Lost Boys. Such a style crush...

    ReplyDelete
    Replies
    1. Cool! It's a timeless look for sure. I would have worn this when I was 14 and I wear them now :)

      Delete
  2. Adorable... I just need to find time and make me one..[copycat for sure,ha]
    Have a happy Thanksgiving.

    ReplyDelete
    Replies
    1. Oh yes, I can really see you in one of these. And for winter you can use heavier fabrics - both of mine are actually made from corduroys and wools xo

      Delete
  3. Ripped crotches in your cotton shorts? That can only come from a burst fufu valve.

    ReplyDelete
  4. Morena MrsC,
    Totally off track but I thought you might like to see what became of the pretty blue and white grosgrain ribbon I bought from you on Halloween (for India, not for Halloween!)
    http://juxtaposenz.blogspot.co.nz/2015/11/what-all-stylish-travellers-are-wearing.html
    And thanks for the post title - it still makes me giggle!

    ReplyDelete